Creedmoor Sports Caliper Anvil

Creedmoor Sports Caliper Anvil

Calipers are the handloaders friend, and they are used to constantly check several critical features during the handloading process. However sometimes it can be a bit tricky to balance a cartridge square on the lower caliper jaw. This is where the Caliper Anvil can help. It securely attached to the bottom jaw via a thumb screw provide a wide and stable circle where you can place the base of the cartridge squarely on the bottom jaw. This is especially helpful when you are using it with a datum tool.

The Anvil may also be used as a quick and easy way to measure a base to ogive. The hole in the center of the tool will allow the meplate of most rifle rounds to pass through, and the edge of the hole will contact the ogive. This gives you a more consistent measurement of seating depth from one round to another at a distance that is close to the tip of the bullet.

Features:

• ¾ in 416 Stainless Steel Construction
• Mounts easily to the lower or upper jaw of a 0-6 or 0-8in calipers
• .137in thru hole allows for quick check of base to ogive measurements.
• Brass thumb screw quickly and securely attaches anvil to caliper. 
• Cartridge Gauge Bell
• Storage Case
• Instructions