Forster Standard Bullet Puller- Collets Not Included

Forster Standard Bullet Puller - Collets not Included
 
If we reload, we all at sometime face the task of having to disassemble cartridges or pull bullets. The Forster Standard Bullet Puller provides the solution to this problem. The Forster standard bullet puller works in most 7/8-14 style reloading presses and is made for a lifetime of use. It uses collets (sold separately) to grip the bullet in a secure manner while reducing damage to the bullet during removal. Provides the user the means to reuse valuable components.

Features:

• Forster Standard Bullet Puller with handle
• Complete instructions included
• Collets sold separately in calibers from .17 caliber to .45 caliber.

Usage:

• Apply a small amount of grease to the tapered portion and base of the collet before inserting collet into puller body.
• Turn the handle counter-clockwise to remove the collet screw from the body. Set aside.
• Insert the collet into the body with the tapered side down. Might be a snug fit.
• Replace the collet screw and turn the handle clockwise to tighten.
• Turn the handle/screw in a clockwise manner so the collet is approximately closed to the diameter of the bullet being pulled. This pre-tightening prevents the case neck from entering the collet.
• Screw the Standard Bullet Puller into the reloading press to a position where the bottom of the collet will just contact the case neck of a loaded cartridge with the ram fully raised.
• Tighten lock ring on bullet puller.
• Insert cartridge into shellholder and raise the ram so the bullet goes into the collet.
• Turn handle clockwise to tighten collet on the bullet.
• Lower ram of reloading press which should extract the bullet from the case.
• Turn the handle of the bullet puller counter-clockwise to release bullet. If bullet doesn't release, tap the top of the screw/handle and it should release the bullet.
• Reuse components or dispose of in a proper manner.