.22-250 Remington Forster Bushing Bump Neck Sizing Die Kit

.22-250 Remington Forster Bushing Bump Neck Sizing Die Kit

The Forster Bench Rest® Bushing Bump Neck Sizing Die Kit includes 3 bushings pre-selected by the Forster staff to accommodate most cases. The die is designed to allow the handloader to control the amount of neck tension or bullet grip while also bumping the shoulder back slightly to allow for correct cartridge headspace length. Using bushings sized for the wall thickness of brass you are using allows you to minimally resize the case which prevents your brass from work hardening from overworking. Forster has interchangeable bushings in .001” increments so you can choose the amount of sizing that occurs. Neck bushings are sold separately. The die also includes a decapping assembly for depriming.

Includes:

• One Forster Bushing Bump Neck Sizing Die
• Three (3) neck sizing bushings pre-selected by the Forster staff
• Decapping assembly
• Complete instructions

Features:

• Sizes the neck based on your selection of the bushing (3 bushings included)
• Bumps the shoulder back providing necessary cartridge headspace for smooth chambering
• Deprimes the case
• Prevents overworking of your brass
• Option of being able to use the expander ball or without depending on uniformity of neck wall thickness
• Superior machined interior finish for smooth sizing
• Made in the U.S.A. 

Tech Tip:

• If neck turning brass completely where neck wall thickness is uniform, the expander ball can be removed so only outside sizing is being done.
• If using brass that is not completely neck turned or not at all, choose a bushing large enough so all the cases are sized enough that the inside diameter is smaller than bullet diameter and leave the expander ball in. That way, all the cases will be minimally sized and not overworked but the expander ball will ensure that all cases have consistent inside diameter for more uniform bullet grip.